General notes – mummification with pallet/cling/stretch wrap/film or bandage
As I've said earlier, this is not a definitive list, but a compilation of ideas and general advice based on a few years of personal experience, plus some generous offerings by fellow practioners. It is bound to be tweaked and improved upon over time
Newbies
Build up the duration in stages and monitor body heat and breathing. 30 minutes the 1st time, then an hour and so on. Check that the person doesn’t have a reaction to the wrap being used by doing a patch test (wear some on the arm only for an hour, for example). If in doubt, use some food-quality film next to the skin first
Heat
The body disperses 70% of its heat through the head. Be very aware of this when fully mummifying anyone. Keep water, straws (if the mouth area is restricted) and a wrap cutter or EMT shears handy
Constriction
Don’t overstretch when applying the wrap as it will shrink and could cause restricted breathing. Some wrap is designed to shrink further under heat, like a hair dryer or heat gun. Be very careful not to constrict or overheat the body more rapidly doing this. If you are applying tape over the top of the film, it is a good idea to pull the tape away from the roll and then lay it on the film, rather than pulling at the roll and making the wrap too tight. If you are not wrapping fingers/toes, be aware that the wrap will force blood to the extremities and could cause problems
Sticky
Blown film is generally tackier than cast film. Some folk like this directly on the skin and some don’t. It restricts limb movement far more, even when sweaty, and pulls the skin very slightly when being peeled off (rather like liquid latex). Skin against skin when sweaty can cause a sweat rash. Some might prefer to use talc, but this can clog the pores of the skin and doesn’t usually mix with sweat so well. A common option is to wrap the arms separately first so that when the outer layers go on it holds the arms firmly in place - or of course you can tie them (not over tight) in place first. It is not necessarily a good thing to yank the wrap off like a plaster or hot wax treatment as it may just have attached itself to the skin a little too well!
Cutting Holes
Vibrators – it may be worth placing this where required prior to wrapping to avoid making larger holes. If you need to cut holes, pinch and cut sideways if the wrap is close to the skin. Using pointy scissors to try and cut normally is not good and is not quite the same as voluntary knife play/blood-letting. Use safety (EMT) shears if you need to cut in this fashion. Nipples can be protected and more easily found if covered by a piece of sponge, 2p coins, some cotton wool or the small plastic caps from drinks bottles prior to wrapping. Genitals may need a larger piece of cotton wool! Try having someone hold a sharp pencil between their legs under the crotch, pointing outwards, so that the wrap can be pierced by it as it is applied. Ice play is fun (over or under the wrap), and very popular as it helps to keep the person cool. Caning or flogging over wrap is perfectly fine also, as long as the person isn’t likely to fall over, and do be aware that bruising can still occur even though the sub is feeling it less. Wax play is unsafe though, as the hot wax can melt the wrap against the skin
Breasts
From a H&S viewpoint, ladies know best. Other than that, all in, nips out or tits out – it’s your choice. If the former, be careful again, not to wrap too tightly
Legs
Wrap them 1st or last? It depends upon the position required. Personally, if the person is to stand unsupported, wrap the legs last, or get a friend to hold your partner steady whilst you apply the wrap – just so they don’t fall over. Falling without the use of one’s hands is not a good thing. Wrapping them to something is always a good option, e.g. if you have rope and an overhead anchor point, you can support them this way. Removing the rope once they’re wrapped is optional
Bony Bits
If ankle or wrist bones are to be wrapped together, it is an idea to place a flannel, a small piece of sponge or something similar between them to avoid rubbing and discomfort
Head
If the head is to be fully wrapped, ensure that breathing is unrestricted through the nose, mouth or both. If the purpose of wrapping the head is specifically for breath play, ensure that an airway can be made rapidly and safely. The wrap can be very hard to pierce or tear with mere fingers, so have safety (EMT) shears or a wrap cutter immediately to hand and make a hole into the mouth which can then be stretched wide. Even a pen or pencil would suffice for this. Incorporating a breathing tube of some kind is an option, but this is not recommended for newbies. Make sure the person can give a clear indication if they need to come out. Always remove wrap from the head first, if applied
Aftercare
Use EMT shears or a wrap cutter to safely cut through the layers of wrap and peel it away. More often than not, the recipient will come out hot and sweaty, but the rush of air will give them a sudden chill. It may be a shock to the body – especially if they are still in a little spaced - so have a blanket ready and apply the usual aftercare